CHECK IT OUT
ELEGOO Mega 2560 The Most Complete Starter Kit provides an open-source electronics prototyping platform based on flexible, easy-to-use hardware and software. It contains all of the essential components required to start programming with the ELEGOO Mega 2560 R3 board, and a free pdf tutorial featuring 33 different lessons for beginner and professional users.
The input voltage of ELEGOO Power Supply Module is 6.5v – 9v (DC) via 5.5mm x 2.1mm plug . Please DO NOT over charge it otherwise it will burn your board and chips.
25pcs LED (white,yellow,blue,red,green)
1pcs RGB LED
10pcs Ceramic Capacitor(22pf & 104pf)
5pcs Diode Rectifier (1N4007)
4pcs Electrolytic Capacitor (10UF 50V & 100UF 50V)
10pcs NPN Transistor (PN2222 & S8050)
1pcs Tilt Switch
5pcs Button (small)
1pcs 1 digit 7-segment Display
1pcs 4 digit 7-segment Display
1pcs Sound Sensor Module
1pcs LCD1602 Module (with pin header)
1pcs IC L293D
1pcs IC 74HC595
1pcs Active Buzzer
1pcs Passive Buzzer
1pcs RTC Module
1pcs DHT11 Temperature and Humidity Module
1pcs Rotary Encoder Module
1pcs Joystick Module
1pcs Keypad Module
1pcs 5V Relay
1pcs IR Receiver Module
1pccs MEGA 2560 R3 Controller Board
1pcs Servo Motor (SG90)
1pcs Stepper Motor
1pcs ULN2003 Stepper Motor Driver Board
1pcs Prototype Expansion
1pcs Power Supply Module
1pcs HC-SR501 PIR Motion Sensor
1pcs Ultrasonic Sensor
1pcs GY-521 Module (with pin header)
1pcs 3V Servo Motor
1pcs MAX7219 Module
1pcs 9V 1A Power Supply
1pcs 65 Jumper Wire
1pcs Water Lever Sensor
1pcs USB Cable
1pcs 9V Battery with DC
1pcs RC522 RFID Module
100pcs Resistor (10R/100R/220R/330R/1K/2K/5K1/10K/100K/1M)
20pcs Female-to-male Dupont Wire
The MEGA 2560 complete starter kit with more than 200pcs components and it is 100% compatible with Arduino IDE.
Free PDF tutorial in the CD (more than 35 lessons). LCD1602 module and GY-61 sensor module with pin header ( no need to solder by yourself). You can also download the same tutorials online from our official website.
Nice package with clear listing and surprise including a nice small box to keep the widget such as LED , IC , buttons , diodes ,etc.
Warning Tip: The input voltage of ELEGOO Power Supply Module is 6.5v – 9v (DC) via 5.5mm x 2.1mm plug. Please DO NOT over charge it otherwise it will burn your board and chips.
Note: To use ELEGOO starter kits requires basic electronic knowledge. If the user has no experience, it would be better to have someone lead and teach them while studying.